1. Vertabelo
  2. Questions
+1
À l'étude

PDF generation problems

Nuo Xu il y a 10 ans • mis à jour par Agnieszka Kozubek-Krycuń (Chief Scientist) il y a 9 ans • 4
when i use print to generate pdf version i came across 2 problems. first one is , when i go back to the edit model, i lost my previous work which i believed it should be aotu saved. Second is , it always breaks my design into several pages which i wanted it to be in one page. Since it beaks my design into several pages, it breaks my tables and references into different pages and makes it hard to read
À l'étude
anonymous il y a 10 ans
+1
anonymous il y a 10 ans
I'll start with the second issue. You can enable an option that shows a grid on the diagram. It presents the boundaries of pages and this way you have full control over the resulting PDF file.
Here's how to setup this option:



Regarding the loss of you work - this definately shouldn't happen. Can you reproduce this scenario? In case of any problems with auto-save you should be shown "Oops, we've got a problem" page disabling further editing.
Don Mason il y a 9 ans
Same issue here. I have set up the properties as Tabloid, margins at 10 and it still creates 6 pages to print, with tables separated. Is there a way to reduce it to at least 2 pages (tabloid) sizes?
Agnieszka Kozubek-Krycuń (Chief Scientist) il y a 9 ans
The gray grid lines show page boundaries. I've checked your model and it spans over 6 pages. You have to move your tables manually so that the model spans over two pages.

Service d'assistance aux clients par UserEcho